I was not sure of where to post this but...I have a YS640 thats about 3 years old. Love it. Recently when the auger would run it would emit an occasional squeak. The other nite when I went to start up the fan turned on and displayed U26, then hit start and a 4 flashed before the 350 rising display and the auger did not turn. Before I dig in any ideas of what I am dealing with? Thanks. Jeff
Here are some things to check:
Remove the pellets and check for any obstruction in the auger.
Remove the 11 screws to remove the hopper end plate, remove the wire to the end plate fan. Check the wires connected to the motor, and check the auger and motor bolts. Here is a document that will take you through this: download/Install%20and%20Repair/Auger%20Bolt%20Fix.pdf
You can also pull the motor and auger out of the cooker to verify there are no obstructions.
When you put the end panel back on, make sure that none of the wiring looms fall between, or on, the fans which could potentially stop the fan from running.
OK Herb,
Finally had a chance to open this up. When cleaned out of pellets the auger starts up but squeaking and then stops. Any ideas short of opening up and pulling the auger? Does the motor have a sensor that shuts it off if the auger is turning improperly? Thanks
Herb,
Upon further inspection the auger drive motor is loose. I assume this could be the problem. I cannot see how to tighten it however or get access to it. Any help appreciated.
I actually got a hold of Joey @ Yoder on a Sunday and he talked us through it. Amazing customer service!
Return to Manuals, Troubleshooting, Best Practices, FAQs, Cooker Registration