New Style Probe Port Assembly
Posted: April 9th, 2017, 6:55 amI just received the New Style Probe port assembly. I would like to know the best way to drill/punch the 1 1/8" hole Will a step drill work? Is the steel too thick for a knockout punch?
Yoder Smokers Community Forum
Welcome to the Yoder Smokers Community.
http://community.yodersmokers.com/
New Style Probe Port Assembly
Page 1 of 1
Posted: April 9th, 2017, 6:55 amRe: New Style Probe Port Assembly
Posted: April 9th, 2017, 1:19 pmA step drill would be best. download/Install%20and%20Repair/A91850%20Procedure%20for%20installing%20a%20factory%20probe%20port.pdf
Re: New Style Probe Port Assembly
Posted: April 19th, 2017, 3:28 pmYoder_Herb wrote:A step drill would be best. download/Install%20and%20Repair/A91850%20Procedure%20for%20installing%20a%20factory%20probe%20port.pdf
I used a Step Drill I purchased from Amazon for around $10.00. Using some dark thread cutting oil on the drill I was able to make a perfect enlargement of the original probe port hole on the right side with no problems at all.