Click the links below to go directly to available resources:
**Frequently Asked Questions**
**Register Your Yoder Cooker**
**Find a Dealer**
**The Yoder Smokers Blog**
November 25th, 2021, 6:03 pm
#1
* Abilene ** Abilene *
  • Joined: November 1st, 2020, 3:02 pm
  • Posts: 2
  • Location: Illinois

After successfully smoking a 17 pound turkey the day before Thanksgiving, I fired up my YS640 on Thanksgiving day to make several side dishes, and after a brief power up to about 140 degrees I noticed the auger stopped feeding the pot. I removed all pellets and could not detect a jam. Tried it again and observed that the auger still does not operate.

What are the best troubleshooting techniques for this issue? I pulled the hopper side panel off and all connections are fine. I’m hoping that I do not have to pull the auger. Are there other things I should do before removing the two allen screws in order to pull the auger? If I do pull the auger I assume it’s only to detect a jam, or is there something else I should do to it or with it once pulled?

The is the first and only “breakdown” I’ve experienced since the smoker’s purchase over a year ago. Bad day for it to happen needless to say.

Advice is appreciated.

November 25th, 2021, 10:51 pm
#2
* Abilene ** Abilene *
User avatar
  • Joined: July 6th, 2016, 11:47 pm
  • Posts: 47
  • Location: Third Planet From The Sun, US of A, CT

Return to Manuals, Troubleshooting, Best Practices, FAQs, Cooker Registration


cron