YS640 Upgrade
Posted: October 10th, 2020, 12:37 am
Hi Folks,
I’m performing a S Series Upgrade on a “new to me” 2018 YS640 and I picked up a YS Series High Flow Pellet Burn Grate when I was doing the Ceramic Igniter. Now my question is a what am I missing/ doing wrong one in that the new burn grate is not sitting flush against the hopper wall.. there is about a half inch gap.. the old grate sits flush..
Thoughts? Likely operator error but I can’t see how and from reading here, said gap is a fire hazard..
I’m performing a S Series Upgrade on a “new to me” 2018 YS640 and I picked up a YS Series High Flow Pellet Burn Grate when I was doing the Ceramic Igniter. Now my question is a what am I missing/ doing wrong one in that the new burn grate is not sitting flush against the hopper wall.. there is about a half inch gap.. the old grate sits flush..
Thoughts? Likely operator error but I can’t see how and from reading here, said gap is a fire hazard..