Discuss, share information, ask questions, and show off your expertise on Yoder Pellet Cookers.

Click the links below to go directly to available resources:
**Pellet cookers** - YS480, YS640
**Competition Pellet cookers** - YS480 Comp, YS640 Comp, YS1500 Comp, Cimarron Comp
**Pellet Cooker Warranty**
October 10th, 2020, 12:37 am
#1
* Abilene ** Abilene *
  • Joined: October 10th, 2020, 12:28 am
  • Posts: 2

Hi Folks,

I’m performing a S Series Upgrade on a “new to me” 2018 YS640 and I picked up a YS Series High Flow Pellet Burn Grate when I was doing the Ceramic Igniter. Now my question is a what am I missing/ doing wrong one in that the new burn grate is not sitting flush against the hopper wall.. there is about a half inch gap.. the old grate sits flush..

Thoughts? Likely operator error but I can’t see how and from reading here, said gap is a fire hazard..

October 15th, 2020, 10:55 am
#2
Site AdminSite Admin
User avatar
  • Joined: August 15th, 2014, 10:48 am
  • Posts: 15

Have you attempted to reshape the burn grate by placing it open face down on a hard surface and stepping on it? Make sure to check fitment after a couple attempts to get the best fit.

October 15th, 2020, 1:27 pm
#3
* Abilene ** Abilene *
  • Joined: October 10th, 2020, 12:28 am
  • Posts: 2

I have not as it is brand new and per Yoder/Atbbq’s product description page it should work in the YS640

Bend wise the upgraded grate is identical to the older save that it is shorter..

I’ll add images shortly

Return to Pellet