Yoder Smokers Community Forum

I upgraded my YS480 to the ACS controller and replaced my temp probe while I was at it as it was broken.

After I got everything installed and fired up, the two external probes have a 35 deg offset to my Pit probe.

The PIT probe is INCORRECT vs the external probes, I verified it with a my normal pit vs food monitor I used to use.

I know I can do a calibration (Read the posts) but good lord, this offset is massive. I am starting to think my new probe is Dead on Arrival..

Anyone else see an offset this big before between pit and external probes on the acs?

Here is the calibration process: http://community.yodersmokers.com/viewt ... =73&t=2033

If you need more help, please contact us directly at customerservice@yodersmokers.com so we may properly help.