Page 1 of 1

Allowable temperature range setting

PostPosted: September 16th, 2019, 7:22 pm
by rcmolski
Hi,

Just got my YS640s about a week ago and did my burn in Sunday. Found a 'cold' spot on the upper left rack, but after reviewing the temperature profile data I think I'll be all right. I'll keep monitoring temps when I start cooking next week or so.


Anyway, I've searched through the forums here and can't quite find what I'm looking for. Also, I don't see this setting documented in my manuals.

I found that by pressing in on the temperature control knob I can change the allowable temperature range from +/- 25 to +/- 5 degrees. I prefer to have the tighter range, so I'd like that to be the default setting. Is there a place I can set that, so I don't have to check or change it with every cook?

Thanks in advance for any help that can be provided.

Bob

Re: Allowable temperature range setting

PostPosted: September 16th, 2019, 8:01 pm
by Yoder_Herb
To change the temperature in 5° increments, just turn the knob up or down for the temperature you would like.

There isn't a "default" setting. Holding the knob in will cause faster changes in temperature setting.

Re: Allowable temperature range setting

PostPosted: September 17th, 2019, 6:59 am
by rcmolski
I'll have to send a picture. To me, it looks like an actual change to a setting in the controller that allows for either +/-25 degree temp swings or +/-5 degree temp swings. It's only pressing and releasing the knob, not holding it in. There is a display on the controller that states what the allowed temp range is set to after releasing the press in.

I understand how to adjust the cooker set temp by turning the knob. This setting is different.

Thanks,

Bob

Re: Allowable temperature range setting

PostPosted: September 17th, 2019, 10:24 am
by Yoder_Herb
Ok, I understand now. This is not the setting of temperature "swings" it is setting how much the set temperature changes for each turn of the knob.

Re: Allowable temperature range setting

PostPosted: September 17th, 2019, 2:23 pm
by rcmolski
Ah Ha!! That makes sense now. I didn't try it out yet, but I will soon. Thought we maybe had the ability to switch between modes on the controller.

Thanks!