Fairly New YS1500
![Post Post](./styles/indulge/imageset/icon_post_target.gif)
Hi Everyone,
I've been here for a little, but am finally getting around to posting. I purchased a used YS1500 a few months ago and was a little disheartened that it hasn't held the temp as consistent as I expected. Admittedly, I hadn't read any of the helpful pages and already see a few things that I need to change. Example, I don't think my chimney is flush and I have been placing the thermometer cords in the front. I'll keep searching, but in case someone sees this post, i have a few questions.
For smoking, is the sliding plate supposed to be completely closed?
Should i just leave the smokestack 50% open at all times?
Is the latest firmware still B20?
Is there a picture of how the burn grate should fit? I read the manual and understand that there shouldn't be more than a 3/16 gap, but id just like to see one. I'm also not sure if the igniter on mine is sitting in the right place. it seems low.
Nice to meet everyone and thanks for the help@
I've been here for a little, but am finally getting around to posting. I purchased a used YS1500 a few months ago and was a little disheartened that it hasn't held the temp as consistent as I expected. Admittedly, I hadn't read any of the helpful pages and already see a few things that I need to change. Example, I don't think my chimney is flush and I have been placing the thermometer cords in the front. I'll keep searching, but in case someone sees this post, i have a few questions.
For smoking, is the sliding plate supposed to be completely closed?
Should i just leave the smokestack 50% open at all times?
Is the latest firmware still B20?
Is there a picture of how the burn grate should fit? I read the manual and understand that there shouldn't be more than a 3/16 gap, but id just like to see one. I'm also not sure if the igniter on mine is sitting in the right place. it seems low.
Nice to meet everyone and thanks for the help@