YS-640 Problem
Posted: December 25th, 2015, 1:00 pm
This morning I removed the cover from my YS-640, vacuumed out the firebox and reinstalled the burn grate, diffuser plate and grills. When I plugged the power cord in, the lower left and lower bottom LED segments of the left most number were illuminated with the power switch in the off position. I unplugged the power cord, waited several seconds and plugged it back in. This time the display was normal with no LED segments being illuminated.
When I turned on the power switch, the controller did not go through the start up sequence and the U code did not flash. However, the blower started, the blue light was on, and the pellet feeder began feeding pellets. The controller display was blank. I turned the power switch to off and unplugged the power cord and check the fuse. The fuse was fine and reinstalled. Again, I plugged in the power cord and turned the power on. I observed the same symptoms; no U code, blue light on, blower running pellet feeder was feeding pellets, and no display on the indicator.
At this time, I turned it off and unplugged the power cord. Fortunately, I also have a Cookshack electric smoker and I prepared it for use so that I could smoke the Prime Rib Roast I had planned for Christmas dinner.
Once, I got my rib roast in the smoker, I went back to look at my YS-640. This time I plugged it in, turned on the power switch and everything appeared to be normal. I didn't not start the unit since my rib roast was already in my Cookshack smoker. I am considering starting it up and letting it come up to full temperature.
Does anyone have any idea what might have happened the first few times I tried to operate my smoker? It worked fine at Thanksgiving and has been stored with the cover installed since then. My YS-640 is just over 1 year old
Thanks,
Jim
When I turned on the power switch, the controller did not go through the start up sequence and the U code did not flash. However, the blower started, the blue light was on, and the pellet feeder began feeding pellets. The controller display was blank. I turned the power switch to off and unplugged the power cord and check the fuse. The fuse was fine and reinstalled. Again, I plugged in the power cord and turned the power on. I observed the same symptoms; no U code, blue light on, blower running pellet feeder was feeding pellets, and no display on the indicator.
At this time, I turned it off and unplugged the power cord. Fortunately, I also have a Cookshack electric smoker and I prepared it for use so that I could smoke the Prime Rib Roast I had planned for Christmas dinner.
Once, I got my rib roast in the smoker, I went back to look at my YS-640. This time I plugged it in, turned on the power switch and everything appeared to be normal. I didn't not start the unit since my rib roast was already in my Cookshack smoker. I am considering starting it up and letting it come up to full temperature.
Does anyone have any idea what might have happened the first few times I tried to operate my smoker? It worked fine at Thanksgiving and has been stored with the cover installed since then. My YS-640 is just over 1 year old
Thanks,
Jim