Page 1 of 1

Ash On Cooking Grates After First 350 Burn

PostPosted: August 25th, 2015, 11:33 am
by BBQ Gary
DSC00933.jpg
DSC00933.jpg (16.78 KiB) Viewed 5660 times
DSC00932.jpg
DSC00932.jpg (17.55 KiB) Viewed 5646 times
Hi All,

Yesterday I received my YS640.

The first thing I did was read the manual that was sent with the unit.

I then leveled my unit and went through the start up procedure as per the manual.

Used Apple BBQ Delight pellets for my initial 350 degree burn. Started fast and I did not peak!

After about 2 hours I turned the unit off and allowed it to go through the cool down process.

After the unit stopped I opened the lid and noticed ash all of the cooking grates. More by the left hand side.

See attached pictures.

In searching the forum it was stated this was normal?

I checked to make sure the diffuser was centered and pushed all the way to the left.

Advice?

Gary

Re: Ash On Cooking Grates After First 350 Burn

PostPosted: August 25th, 2015, 1:29 pm
by Yoder_Herb
There will be some ash, but as you get more cooking done on the grill, you should see it subside. If it really bothers you, you can put a small amount of foil over the end of the heat diffuser to block the airflow from the small hopper end open area.

Re: Ash On Cooking Grates After First 350 Burn

PostPosted: August 25th, 2015, 1:35 pm
by BBQ Gary
Herb,

Thanks for the quick reply and advice.

Just wanted to make sure that was normal prior to a heat test with some bacon.

Re: Ash On Cooking Grates After First 350 Burn

PostPosted: August 25th, 2015, 1:40 pm
by Yoder_Herb

Re: Ash On Cooking Grates After First 350 Burn

PostPosted: August 26th, 2015, 10:10 am
by jeetS
once you get a few cooks on it I doubt you will see ash anymore.
I dont ever see it anymore

Re: Ash On Cooking Grates After First 350 Burn

PostPosted: August 27th, 2015, 6:29 am
by Conumdrum
Hehe, I get a bit when I cook steaks. Not on long lower temps. Stuff sicks to the sides etc. And it doesn't need cleaned except the once a year scrape with a plastic scraper, cheap in the Home Depot paint department. Just need to vacuum the bottom and burn pot each time and every once and a while scrape the bottom if you must. I get chunks at times when cooking 6 butts at once for 12 hours right in the middle of the bottom. Lotta grease and ash. Not that much, but need to take care of you're expensive, awesome cooking machine.

Re: Ash On Cooking Grates After First 350 Burn

PostPosted: August 27th, 2015, 9:30 am
by BBQ Gary
Thanks to everybody who has responded! Great advice.

Re: Ash On Cooking Grates After First 350 Burn

PostPosted: November 11th, 2015, 8:12 pm
by dawktah2
What is the damper position during the test?