Page 1 of 1

YS640 blows fuse after startup

PostPosted: December 29th, 2019, 11:52 am
by Muhatmahadji
My YS640 blows the blows the fuse 4 mins after start. Igniter gets hot enough to light the pellets before the fuse blows. If I disconnect the igniter and use a lighter to light the pellets, the fuse does not blow. Will replacing the igniter resolve this issue? If so, do you recommend I replace with the YS Series Ceramic Pellet Grill Igniter? My YS640 was manufactured on 040418, serial number 37337, has firmware U29 installed and delivered May 18.

Re: YS640 blows fuse after startup

PostPosted: December 29th, 2019, 11:57 am
by Yoder_Herb
Yes, replace the igniter.

The ceramic igniter has a 3 year warranty, but does not preclude the requirement to remove the ash from the burn grate prior to each use.

Re: YS640 blows fuse after startup

PostPosted: December 29th, 2019, 12:04 pm
by Muhatmahadji
Thank you for the quick response to my query. I do remove the ash from the burn grate before every smoke. I'll order a ceramic igniter today. Hope you have a great New Year!