Got my YS640 today! Couple quick questions
Posted: March 29th, 2017, 5:12 pm
I got my YS640 today and it's currently outside doing the initial burn. I read through the manual but I admit I didn't sit down and really take my time. I got the two piece diffuser and thats what I have in there now. My question is, I know the original diffuser wasn't supposed to be used above 400 degrees, can the two piece be used hotter than that? I've read where people have had it in there and turned it up all the way to sear. Is that ok?
Second the rubber piece that goes in the new probe hole....is it safe to leave in until you need to use the hole? I couldn't find anything about it in the manual.
Thank you and I can't wait to really use this thing.....boy everyone was right too...it's built like a tank.
Second the rubber piece that goes in the new probe hole....is it safe to leave in until you need to use the hole? I couldn't find anything about it in the manual.
Thank you and I can't wait to really use this thing.....boy everyone was right too...it's built like a tank.