Hi,
I received my Loaded Wichita some month ago and begin to be not too bad with it
I really enjoy it a lot, it took me almost 3 years to find a reseller able to ship one to Belgium, but the wait was really worth it.
I just have on small issue, temperature. Or to be more precise, thermometer.
I must be doing something wrong, but I always have about 100°F between the one next to the firebox and the upper one next to the chimney.
See the image attached.
Did you try swapping the yoder thermometers to see if you get the same results? Maybe you have a bad analog thermometer.
I too have a loaded Wichita, my temperature difference is about 50 degrees between the two factory thermometers. I run a maverick digital also, on the cooking grate, it typically reads between the factory gauges. One of your gauges may be bad.
on my kingman with a heat plate, the best I can ever get is 50 on a good day, usually closer to 60-70 degree difference, not really that big of a deal because you'll learn to start using cooler/hotter spots to your advantage, and also allows you to do chicken/pork cooks at same time.
I received my Yoder Loaded Wichita this past Tues and I finally got a chance to season it last night. Now I don't know if the seasoning temp process is different than actually cooking in it.
At start up I also experienced the wide side to side temp variation as do most here have mentioned but once the pit got hot and stabilized the temps also stabilized from side to side.
What I did was use heavy duty foil to close down the huge gaps where the HMP comes in contact with the firebox/main chamber wall particularly the corners. Also laid foil on the first 6-8" flat area of the plate. I'm thinking this forces the heat to go underneath the plate and not rise to the grate (known hot spot) immediately next to the firebox.
Now I don't know if this will translate when actually cooking.....but for now, I am very happy with the results.
I will try to attach photos of the thermometers.
Thanks,
Gus
Edited to add: Yoder....I noticed the thermometers on my Wichita are Tel-Tru......has this always been the case?? Either way.....NICE.
superlead73 wrote:I received my Yoder Loaded Wichita this past Tues and I finally got a chance to season it last night. Now I don't know if the seasoning temp process is different than actually cooking in it.
At start up I also experienced the wide side to side temp variation as do most here have mentioned but once the pit got hot and stabilized the temps also stabilized from side to side.
What I did was use heavy duty foil to close down the huge gaps where the HMP comes in contact with the firebox/main chamber wall particularly the corners. Also laid foil on the first 6-8" flat area of the plate. I'm thinking this forces the heat to go underneath the plate and not rise to the grate (known hot spot) immediately next to the firebox.
Now I don't know if this will translate when actually cooking.....but for now, I am very happy with the results.
I will try to attach photos of the thermometers.
Thanks,
Gus
Edited to add: Yoder....I noticed the thermometers on my Wichita are Tel-Tru......has this always been the case?? Either way.....NICE.